In this part I will tell as did a seat. For a start I cut out a seat basis from balsa. I cut out a sealant of a seat from a packing material and a box of the switcher . I have pasted all this on a basis.
As an upholstery I use thin to skin substitute.
At first I moisten one edge with glue and I paste in skin to substitute. Behind that I paste by the same method lateral faces. On corners I try “to pull” as if skin on a corner. The last I paste the last side. After glue excess skin dries I cut off an edge. Here and the seat turns out.
I do by the same method seat sidewalls.
For a seatback at first I cut out a template and I adjust it in the place. Behind that I cut out a plate from balsa and I fit to skin substitute as a seat.
There now somehow so. The seat is ready, it was necessary to make imitation of an insertion. For this purpose I used small brass nails which I blackened. Behind that on a marking I just stuck them in a seat through. I fixed nails from a reverse side, having greased them at first with glue. Later I cut off superfluous. Most I have made also on a sitting back.
Here the seat is also ready. But I haven’t pasted him into place yet – still early.
