Part 4

      No Comments on Part 4

Brush, having diluted construction hard putty of Handycoat with water, I have covered a model body surface. I covered with a thin layer twice.
20160324_164320
20160324_164351
After that I have smoothed out everything an emery paper 600 and 800. Where there were hollows has puttied once again and too a brush.
20160325_104037
20160325_104047
20160325_104054
Behind that I used spray of an automobile primer, previously having stuck the bottom and a seat with a painting adhesive tape. It is better to leave these places not painted over. After that I have processed all surface 1000 emery paper. Where it is necessary I puttied.
20160325_145512
20160325_145539
And the final – coloring. Paint in a barrel from the Korean producer. Generally somehow so20160325_155492
20160325_155494
20160325_163307

Part 3

      No Comments on Part 3

Well, when the detail has dried, it has taken the necessary form. In general, the made matrix is useful still more than once.
20160323_075649
I start sitting assembly further. Quite difficult element because of the rounded shapes. I curved sidewalls on that matrix. At first I have pasted sidewalls, and then a back wall. Though it is more logical former to glue all this at the same time.
20160323_100411
20160323_110626
20160323_110559
Behind that I have made fitting. it seems looks normally.
20160323_125940
I have anew made a side decor of continuation of sidewalls of a seat. So best of all.
20160324_080501
I have pasted a seat to a basis. After that I have covered with hard putty and I have processed a skin a cowl.
And only after that I have pasted a decor. I have begun to collect back part. As well as in a lobby I have inserted lugs for strengthening.
20160324_121702
There now and all. The case is finished. Ahead preparation for painting by means of hard putty and a primer.
20160324_145423
20160324_145443
20160324_145639

Part 2

      No Comments on Part 2

Well, we will start. The plan of model in the section drawings.
We separate the first details of nasal part of a car and we number according to an arrangement on the plan. It is better to make it in advance, and that you will get confused.
20160322_082114
We glue cheeks, trying under 90 degrees. I used a square.
20160322_084819
After that I have strengthened a design from within. Also it has been made also because with a bottom will be fastens springs, and sideways lamps. Lugs from a birch.
20160322_091745
And further we collect also by glue a nose cowl. I cut out two details from the balsa – the sizes nearly coincided.
20160322_101831
20160322_102128
20160322_110642
While there is an access has puttied a cowl from within. Hard putty on a tree though I like Korean Handycoat more. She is much softer and simpler in processing. I will use her, but not now.
20160322_114433
The following step – the case with a seat. It has appeared when fitting likely a detail most difficult here. Difficult because there are a lot of curvatures. Also we number everything.
20160322_114859
The back wall should be bent. For this purpose I use a template from a framework of details. Also I have stuck together an angular detail of a seat and I have strengthened it balsa laths from within. So, just in case.
20160322_140009
From personal reserves of balsa I cut preparation for a matrix on which I will bend a back wall.
20160322_141341
There is such matrix. And further I have filled in preparation with boiled water, I have sustained some time and I have recorded on a matrix. Everything, we will wait.
20160322_152259